 |
| Titel |
Modelling the interaction of the bedrock and slope in terms of drainage and exfiltration |
| VerfasserIn |
Amin Askarinejad, Patrick Bischof, Francesca Casini, Cornelia Brönnimann, Sarah M. Springman |
| Konferenz |
EGU General Assembly 2011
|
| Medientyp |
Artikel
|
| Sprache |
Englisch
|
| Digitales Dokument |
PDF |
| Erschienen |
In: GRA - Volume 13 (2011) |
| Datensatznummer |
250052226
|
|
|
|
|
|
| Zusammenfassung |
| Water may infiltrate in the soil mass and reach the soil-bedrock interface during and after a
rainfall event. Depending on the permeability of the bedrock, infiltrated water can generate a
perched water table. This water table may either rise, increasing the degree of saturation, or
decrease, causing negative pore pressures (suctions) to develop in any capillary zone.
Decrease in the suction decreases the shear strength mobilised in the material, which may
trigger failure. A test field (average slope of 38° and ~250 m2 area) was selected
near Ruedlingen (Canton Schaffhausen, Switzerland) where landslide triggering
experiments were carried out in autumn 2008 and spring 2009. The experimental site is
located in the Swiss Molasse basin. The lithological units in the area are composed of
horizontally layered sandstones intersected by coloured marlstones both of the Lower
Freshwater Type. Above the test site is the transition to the layered sandstones of the
Upper Marine Molasse (OMM) (Brönnimann, 2010). The slope was subjected to
extreme artificial rainfall in October 2008 over a period of 4 days. Some surface
movements were detected during this extreme event, although failure did not occur
(Springman et al., 2010). Subsequently, a range of measures were implemented,
such as relocating the distribution of the sprinklers to provide more rainfall to the
upper part of the slope, so that a failure was triggered in March 2009, incorporating
about 130 m3 of debris. In order to compare the experiments of 2008 and 2009, the
transient process of rain water infiltration in the soil and the effect of the topography
and drainage properties of the bedrock at the lower part of the slope on the pore
pressure distribution are investigated. The finite element method is used to simulate the
percolation process of infiltrated water into the soil. The stability of the slope is
monitored at different stages of the infiltration using the limit equilibrium method of
slices. Several cases were compared to study the effect of the fissure geometry
and hydraulic properties. The approximate location and size of the fissures in the
bedrock were determined by monitoring of spatial and temporal changes of electrical
resistivity during rainfall and also visual investigations of the bedrock after the
failure.
According to these simulations, the slope might have failed during the first experiment if
there had been no “drainage fissures” in the lower part. Also, the interconnected
fissures and the horizontal intrusion of a very permeable sandy layer in the upper part
of the slope was found to affect the slope stability. Nevertheless, the impact of
the drainage and horizontal fissures is different. The latter have a storage function
that can delay reaching and accumulating the water at the interface of the soil and
bedrock. |
|
|
|
|
|
|