![Hier klicken, um den Treffer aus der Auswahl zu entfernen](images/unchecked.gif) |
Titel |
Petrophysical characterization of first ever drilled core samples from an active CO2 storage site, the German Ketzin Pilot Site - Comparison with long term experiments |
VerfasserIn |
Kornelia Zemke, Axel Liebscher |
Konferenz |
EGU General Assembly 2014
|
Medientyp |
Artikel
|
Sprache |
Englisch
|
Digitales Dokument |
PDF |
Erschienen |
In: GRA - Volume 16 (2014) |
Datensatznummer |
250098618
|
Publikation (Nr.) |
EGU/EGU2014-14310.pdf |
|
|
|
Zusammenfassung |
Petrophysical properties like porosity and permeability are key parameters for a safe
long-term storage of CO2 but also for the injection operation itself. These parameters may
change during and/or after the CO2 injection due to geochemical reactions in the reservoir
system that are triggered by the injected CO2.
Here we present petrophysical data of first ever drilled cores from a newly drilled well at
the active CO2 storage site - the Ketzin pilot site in the Federal State of Brandenburg,
Germany. By comparison with pre-injection baseline data from core samples recovered prior
to injection, the new samples provide the unique opportunity to evaluate the impact of CO2
on pore size related properties of reservoir and cap rocks at a real injection site under in-situ
reservoir conditions. After injection of 61 000 tons CO2, an additional well was drilled and
new rock cores were recovered. In total 100 core samples from the reservoir and the
overlaying caprock were investigated by NMR relaxation. Permeability of 20 core samples
was estimated by nitrogen and porosity by helium pycnometry. The determined data are
comparable between pre-injection and post-injection core samples. The lower part of the
reservoir sandstone is unaffected by the injected CO2. The upper part of the reservoir
sandstone shows consistently slightly lower NMR porosity and permeability values in the
post-injection samples when compared to the pre-injection data. This upper sandstone
part is above the fluid level and CO2 present as a free gas phase and a possible
residual gas saturation of the cores distorted the NMR results. The potash-containing
drilling fluid can also influence these results: NMR investigation of twin samples
from inner and outer parts of the cores show a reduced fraction of larger pores for
the outer core samples together with lower porosities and T2 times. The drill mud
penetration depth can be controlled by the added fluorescent tracer. Due to the
heterogeneous character of the Stuttgart Formation it is difficult to estimate definite CO2
induced changes from petrophysical measurements. The observed changes are only
minor.
Several batch experiments on Ketzin samples drilled prior injection confirm the results
from investigation of the in-situ rock cores. Core samples of the pre-injection wells were
exposed to CO2 and brine in autoclaves over various time periods. Samples were
characterized prior to and after the experiments by NMR and Mercury Injection Porosimetry
(MIP). The results are consistent with the logging data and show only minor change.
Unfortunately, also in these experiments observed mineralogical and petrophysical changes
were within the natural heterogeneity of the Ketzin reservoir and precluded unequivocal
conclusions.
However, given the only minor differences between post-injection well and pre-injection
well, it is reasonable to assume that the potential dissolution-precipitation processes appear to
have no severe consequences on reservoir and cap rock integrity or on the injection
behaviour. This is also in line with the continuously recorded injection operation parameter.
These do not point to any changes in reservoir injectivity.| |
|
|
|
|
|