 |
| Titel |
A new flow law for Bischofite |
| VerfasserIn |
Nawaz Muhammad, Chris Spiers, Hans De Bresser, Colin Peach |
| Konferenz |
EGU General Assembly 2014
|
| Medientyp |
Artikel
|
| Sprache |
Englisch
|
| Digitales Dokument |
PDF |
| Erschienen |
In: GRA - Volume 16 (2014) |
| Datensatznummer |
250096953
|
| Publikation (Nr.) |
 EGU/EGU2014-12489.pdf |
|
|
|
|
|
| Zusammenfassung |
| Bischofite exits in the upper crust with its related minerals carnallite, sylvite and halite,
and is known as the most ductile material within the halide family of minerals.
It is normally extracted from the subsurface by solution mining in underground
caverns. Abandonment of the caverns causes the wall rock to creep towards the
inside due to overburden stress, which in turn results in subsidence at the surface.
In order to allow reliable prediction of the creep of Bischofite at cavern walls, a
well-defined flow law is required that can be applied at strain rates at least as low as 10-9
s-1. Such rates are difficult to achieve in the laboratory. We have conducted new,
conventional axi-symmetric compression tests on as-received polycrystalline Bischofite
samples from natural cores. The experiments have been carried out at near real in situ
conditions of temperature and pressure (70oC and 40 MPa, respectively), using a range
of strain rates from 10-5 to 10-8 s-1. All experiments were strain rate stepping
experiments including stress relaxation after every step down to strain rates of 3x10-9
s-1. In the relaxation part of the experiments, the deformation piston was arrested
at fixed position and the stored elastic energy in the sample and in the machine
was allowed to relax through plastic deformation of the sample. The measured
mechanical data were used to obtain the stress exponent (n) as included in a conventional
(Dorn-type) power law. We observed that during the stress relaxation, the n-value
gradually changed from n >5 at 10-5 to n ~1 at 10-9 s-1. The absolute strength
of the samples remained higher if the relaxation started at a higher stress, i.e. at
a faster rate within the range tested. We interpret this as indicating a difference
in microstructure at the initiation of the relaxation, notably a smaller grain size
related to dynamical recrystallization during the constant strain rate part of the
test just before relaxation. The data thus suggest that there is gradual change in
mechanism with decreasing strain rate, from grain size insensitive (GSI) dislocation creep
to grain size sensitive (GSS) pressure solution creep. We propose that a hybrid
flow law in which strain rate is equal to A′Ïănexp(Ïă/B) should best be applied to
describe the flow of Bischofite at in situ conditions of 70oC, 40 MPa and slow
strain rate. Best fit analysis resulted in values n=3.4, A′= 10(-8.519) and B = 2.26. |
|
|
|
|
|
|