![Hier klicken, um den Treffer aus der Auswahl zu entfernen](images/unchecked.gif) |
Titel |
Development of a Compact VLBI System for Providing over 10-km Baseline Calibration and Its Implications to Geodesy and Precise Time Transfer |
VerfasserIn |
R. Ichikawa, A. Ishii, H. Takiguchi, Y. Koyama, T. Kondo, S. Kurihara, K. Kokado, S. Matsuzaka |
Konferenz |
EGU General Assembly 2009
|
Medientyp |
Artikel
|
Sprache |
Englisch
|
Digitales Dokument |
PDF |
Erschienen |
In: GRA - Volume 11 (2009) |
Datensatznummer |
250023977
|
|
|
|
Zusammenfassung |
    We are developing a compact VLBI system with 1.6 m diameter aperture dish in order to
provide reference baseline lengths for calibration. The reference baselines are used to validate
surveying instruments such as GPS and EDM and maintained by the Geographical
Survey Institute (GSI) of Japan. The compact VLBI system will be installed at
both ends of the reference baseline. However, it is too insensitive to detect fringe
between both stations using such compact dish. Thus, we have designed a new
observation concept including one large dish station into the baseline observation. We can
detect two group delays between each compact VLBI system and the large dish
station based on conventional VLBI measurement. A group delay between the two
compact dishs can be indirectly calculated using a simple equation. We named the idea
‘Multiple Antenna Radio-interferometry of Baseline Length Evaluation (MARBLE)’
system. The compact VLBI system is designed to be assembled with muscle power
simply in order to perform short-term (about one week) measurements at several
reference baselines in Japan islands. The compact VLBI system is also capable
to be used as a fiducial station of a local geodetic observation network at remote
locations.
    We have evaluated a front-end system with a wide-band quad-ridged horn antenna
(QRHA) by installing it on the 2.4 m diameter dish at Kashima. The 2.4 m VLBI station is
operated in order to test equipments which will be planed to install on the compact VLBI
system. On December 5 of 2007, we have successfully detected first fringes of the 3C84
signal for S/X band using the new front-end system. Moreover, we have succeeded to perform
two geodetic VLBI experiments on 54 km baseline between the 2.4 m dish equipped with the
QRHA and the Tsukuba 32 m station of GSI. The results of determined baseline
length between the 2.4 m station and Tsukuba 32 m station are almost identical
with the previous results which are used by X-band feed only on the 2.4 m dish.
On the other hand, the formal error of recent results are slightly worse due to low
signal-to-noise ratio (SNR) of signal fringes caused by low aperture efficiency of the
antenna. Since the new 1.6 m dish is optimized for the new front-end, we expect
SNR of the new system will improve. We are now preparing to perform first fringe
detection experiment using the compact VLBI system with 1.6 m dish in March of
2009. In addition, we are also planning to use the system into the accurate time and
frequency comparison between a separated locations and we will present its outlook. |
|
|
|
|
|